MIL-DTL-22442/29B(AS)
NOTES:
l.
All dimensions are in inches.
2.
Tolerances are metal parts ±.005, molded sections ±.05 inches unless otherwise specified.
3.
This specification supersedes Naval Air Systems Command Drawing 765AS380.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
asterisks to indicate where changes from the previous issue were made. This was done as a
convenience only and the Government assumes no liability whatsoever for any inaccuracies in
these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to the
last previous issue.
Preparing activity:
Navy - AS
(Project No. 5995-0l28-11)
3