MIL-DTL-22442/4C(AS)
8. The pins shall be capable of moving slightly in any direction to ensure Requirement 4 is
met when used with the mating connector. The rear of the connector shall provide a hole
for the cordage. The hole shall be on the centerline of the connector and shall be sized to
clamp the cordage used on the cable assembly.
*9. The M22442/4-2 connector shall contain an impedance matching transformer in
accordance with M22442/1-7.
TABLE I. PART NUMBERS
*
PART NUMBER
M22442/4-1 (U61/U)
WITH OUT TRANSFORMER
M22442/4-2
WITH TRANSFORMER (M22442/1-7)
NOTES:
1. Dimensions in inches. Unless otherwise specified, tolerances:
Metal parts + .005
Molded sections + .05
2. This specification supersedes USAF Drawing 46D40829.
*3. The parts specified on this specification sheet are for use on completed and tested
cable assemblies. Qualification of individual parts and components is not required.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
asterisks to indicate where changes from the previous issue were made. This was done as a
convenience only and the Government assumes no liability whatsoever for any inaccuracies in
these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to the
last previous issue.
Preparing activity:
Navy - AS
(Project No. 5995-0l28-03)
3