INCH-POUND
MIL-DTL-22442G
25 September 2009
SUPERSEDING
MIL-DTL-22442F
1 April 2000
DETAIL SPECIFICATION
CABLE ASSEMBLIES, AIRCRAFT AUDIO,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and Agencies of the Department
of Defense.
1. SCOPE
1.1 Scope. This specification covers the general requirements for complete cable
assemblies, with molded or attached plugs including any required built-in electronics, used in
aircraft intracommunications and intercommunications systems. It covers cord sets for personal
gear such as microphones, headsets, earphones, hand sets and similar equipment, and cable
assemblies for contact with ground crew personnel.
1.2 Part or identifying numbers (PIN). Part numbers for cable assemblies should be
constructed as follows: M22442/X-Y with "X" being the specification sheet number and "Y"
being any type cable assembly on a specific specification sheet.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements documents cited in sections 3 and 4 of this specification, whether
or not they are listed.
Comments, suggestions, or questions on this document should be addressed to: Commander,
Naval Air Warfare Center Aircraft Division, Code 4L8000B120-3, Highway 547, Lakehurst, NJ,
08733-5100, or emailed to: michael.sikora@navy.mil. Since contact information can change,
you may want to verify the currency of this address information using the ASSIST Online
database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5995
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business