MIL-DTL-22442G
4. VERIFICATION
4.1 The text of this paragraph has been deleted. The paragraph number is retained in order
to maintain the numbering sequence for inspections and tests that are referenced in the tables of
many specification sheets listed in supplement 1 to this document.
4.2 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. Qualification inspection (see 4.3).
b. Conformance inspection (see 4.4).
4.3 Qualification inspection. Qualification inspection shall be performed in accordance
with the provisions of SD-6. The qualification inspection shall consist of all Group I tests
specified in table I of the specification sheet for each cable assembly. The qualification
inspection sample shall consist of fifteen units of each cable assembly for which qualification is
desired. At least two of the fifteen units shall be considered control samples, and only Group IA
tests shall be performed on these units until the event of a failure. Group IA inspections shall be
performed on each of the fifteen sample items. At least two samples shall be submitted to each
of the Group I (B, C, and D) inspections. In the event of a single failure, one of the control
samples shall be submitted to the failed test sequence. If a second failure occurs, qualification
shall be denied.
4.3.1 Qualification samples. Items for qualification must be separately packaged and
forwarded to the activity responsible for qualification as designated in the letter of authorization.
The sample shall in all respects be representative of the manufacturer's production item. Each of
the items shall be subjected to the applicable inspections specified in Group I of table I of the
specification sheet. Samples shall be marked in accordance with 3.4.13 except the items shall
also be marked (Qualification Samples) and shall include the applicable specification number,
and shall reference the letter authorizing the tests.
4.3.1.1 Retention of qualification. The activity responsible for requalifying cables to this
specification shall specify what tests are required.
4.3.2 Acceptance of final product. Acceptance or approval of material during course of
manufacture shall in no case be construed as a guarantee of the acceptance of the finished
product. Acceptance of the finished product shall be upon a lot basis after satisfactory
completion of all required tests. Acceptance tests shall consist of Group II and Group III tests in
table I of the specification sheet for the specified cable assembly.
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business